How to Install a Rock Light Kit

Whether you want to light up the tracks or your campsite, the Adventure Kings Rock Light Kit is the perfect choice! Easy to install just about anywhere and able to output orange or white light this kit is so multipurpose!

Includes a 1.5m power cable for each of the four lights and connecting to a 4-into-1 harness powered by a Deutsch style plug - that means it's super easy to connect up to a Kings Wiring Harness, 12V Control Box or Touch Pad Switch Panel whether you need lighting underneath your vehicle or to light up your camping setup.

PARTS REQUIRED	Adventure Kings Rock light / Accessory Light Kit, Adventure Kings Plug N play Smart Harness (optional)
TOOLS REQUIRED	Wire stripper, drill, 4mm-4.5mm drill bit, deburring tool, lighter or heat gun, crimper, marker
MATERIALS REQUIRED	Masking tape, touch-up paint, cable ties, terminal clips, positive and negative wiring with deutsch plug (optional if no wiring harness), heat shrink, 10A fuse

PROJECT OVERVIEW

STEP 1

To mount the lights, place LED Rock Light in desired location, ensuring there is sufficient length to reach your switch location. Check your local regulations to ensure you mount them in a legal location on the vehicle.

STEP 2

Clean the area and mark mounting points. You can use masking tape to make it easier. Add the rubber mount to the back of the light and feed the wire through. Cut a notch out of the rubber so the wire sits flush.

STEP 3

Drill pilot holes in marked points, then drill holes with a 4mm-4.5mm drill bit. Deburr the hole and add paint to the area to prevent rust.

STEP 4

Attach the light using provided mounting pads and included nuts, bolts and washers. If mounting to a tube-bar or rounded surface, the curved mounting pad would work best. Add a thread-locking compound to help prevent the nut from getting loose when off-road.

STEP 5

Connect all four of the Lights to the splitter harness.

STEP 6

Connect splitter to desired switch. If you’re using a KINGS wiring harness, cut the trigger wires off the harness and attach a fuse and terminal to the positive, and a terminal to the negative. As these need to be connected directly to the battery so you aren’t relying on a high beam trigger. Cut the wiring short if needed to keep it tidy. OR if you’re using a touch pad switch panel you need a two-pin deutsch plug, the positive connected to one of the screw terminals in the fuse box and earth the negative wire. Light colour interchanges when turning off and on. Eg On: White, Off, On: Amber